1This ADF4351 signal source development board has well designed circuit board layout. 2It can be controlled by the upper computer official software. 3All control pins are leaded out for convenient operation. 4Default + -50ppm 25M active crystal oscillator. 5Three-wire serial peripheral interface bus lead to control pin and state locking pin, allowing all functions including point frequency sweep and frequency hopping.Features: This ADF4351 signal source development board has well designed circuit board layout.It can be controlled by the upper computer official software.All control pins are leaded out for convenient operation.Default + 50ppm 25M active crystal oscillator.Threewire serial peripheral interface bus lead to control pin and state locking pin, allowing all functions including point frequency sweep and frequency hopping. Specifications: Output frequency range: 35MHz 4.4GHzSupply voltage: 49V (5VDC) Output signal: 2.2GHZ4.4GHz sine wave (fundamental) 35MHZ2.2GHz squarewave (fundamental division) Output signal: output speed, signal strength: + 5dBm (programmable) RF connector: SMA female head Control Interface: Threewire Serial Peripheral Interface Bus Reference Clock: 10.000MHZ (default), through the interface to an external SMA Size: Approx. 4.8 x 4.9cm / 1.89 x 1.93inch Weight:15g Connection:The module can pin microcontroller LCD1602 / LCD12864 module connection (can be plugged directly Backward), convenient software debugging, both lock indicator (Lock). Pin correspond to the following: 1.GND GND 2.VDD (5V) VCC 3.VO NC (empty) 4.RS NC (empty) 5.R / W MUXOUT 6.EN CLK 7.DB0 DATA 8.DB1 LE 9.DB2 CE (has 10K pullup) 10.DB3 GND (do not take) Reference Clock: 10.000MHZ default reference clock signal is active clock or an external reference clock signal, you need to modify the threeway connection with a soldering iron, connect EXT_REF external reference signal. RF output: For ease of use, the default is broadband output, the output of two differential si